| |
Step One: Placement
Once the slab has been finished, and if applicable, curing blanket has been installed, roll out the PolarCure insulation blanket on top of the slab with the silver side facing up and the black side toward the concrete.
|
Step Two : Taping & Remove Gaps
Once the first PolarCure blanket is installed, continue by rolling out adjacent blankets insuring that the blankets are lapped and there are no gaps exposing the slab to the elements. Secure the laps using either duct tape or by placing weight, such as lumber, over the laps to prevent from separating. Continue layering the blankets until the entire slab is covered. DO NOT CUT OR PUNCTURE THE OUTER LAYERS OF THE POLARCURE INSULATION BLANKET.
|
Step Three : Weighing & Repair
Secure the PolarCure insulation blanket at the perimeter of the slab by placing weight, such as lumber, on top of the PolarCure insulation blanket.
Inspect the blankets for holes prior to and after the installation to ensure that the outside layers have not been punctured. If holes are found, simply tape over using duct tape or any other water proof tape.
|
Step Four : Duration
Leave the PolarCure insulation blanket down for the duration of the curing period of the concrete slab to ensure proper curing.
|
Step Five: Removal Repair
To remove, simply roll up the PolarCure insulation blanket and secure by tying together using the eyelets around the perimeter of the blanket.
Store in a dry and secure area to insure blanket will not be damaged.
|
Precautions:
*Keep away from fire and flame.
*Store in a cool dry place.
*Always use proper PPE (personal protective equipment) when working around fresh concrete.
*No warranties implied or otherwise are given for the usage of this product.
For additional information contact: McTech Group, Inc. 770-913-8363 / 1-866-913-8363
|
|
| |
| |
